Take your first sheet of metal and place it on the roof so that it overhangs the edge at least 3 4 in 1 9 cm.
Metal roof edge trim installation.
Two slopes meeting on your metal roof need their own metal.
The peak of your metal roof needs a different trim from the gables.
Position a piece of 2 by 2 inch metal roof edge at the lower edge of the roof with the beveled side against the.
Trim is an important element of roof assembly as each different section of metal roofing will require a trim specific to that area.
Butyl sealant tape should be placed parallel to the gable on the high seam of the roofing panel.
Use your neoprene washer head screws to secure the metal to the sheathing.
Place the first screw.
Move the piece as necessary so one end extends 16 inches beyond the lower corner of the roof at one side.
Fastening prior to fastening gable trim remove all protective plastic from gable trim.
Do you need to install eave or fascia for a metal roof.
Here is a short video showing how.
If the panel is allowed to hang over the gable end eave drip can be used instead.
Metal eave trim sometimes called eave drip pieces redirect rain runoff away from the perimeter of the roof fascia.
Lap screws should be placed 12 on center hitting the.
Install the roofing screws vertically along each rib in the panel.
Take care the first piece is aligned precisely perpendicular square to the edge.
The edge of your metal roof needs a different trim than the peak of your metal roof.
Place the piece of edging on.
How to install gable trim for an exposed fastener vicwest metal roof.
Space the screws about 12 in 30 cm apart down the entire piece of metal.
Be sure the larger edge is laid so that the small edge of the next panel will overlap it.
Interfacing with the gutter or drainage system it is installed on the lowest point on the roof and must handle any runoff from the roof s upslope portions.
It should match the eave drip that extends along the drip edge of the roof.
Fasten gable trim with x inch metal to metal lap screws.